Skip to content

30% off your first paymentends Nov 30Plans

KDP cover size calculator. Full wrap, in pixels too.

Pick a trim size, page count and paper to get the size of the whole paperback cover file: back, spine, front and bleed, in inches, millimeters and pixels at 300 dpi.

Width × height of the finished book
Final PDF, including blank pages
Ink and paper, as on KDP

Your cover file

Full cover, width × height

12.7 × 9.25inches

Millimeters

322.6 × 235.0 mm

whole file

Pixels at 300 dpi

3,810 × 2,775 px

width × height

Spine width

0.450 in

11.4 mm

Bleed

0.125 in

0.125 in on the top, bottom and outside edges

How to size a KDP paperback cover

A paperback cover is one flat file that wraps the whole book: the back cover, the spine and the front cover, with a little extra artwork past the trim line so no white edge shows after cutting. Its size depends on the trim size, the page count and the paper.

width = bleed + trim width + spine + trim width + bleed
height = trim height + 2 × bleed

The bleed is 0.125 inches on the top, bottom and outside edges. The spine is the page count times the paper’s per-page width, so a thicker book gives a wider file; the spine width calculator shows that part on its own.

Worked example. A 6 × 9 in book of 200 pages on black ink, white paper has a 0.450-inch spine, so the file is 0.125 + 6 + 0.45 + 6 + 0.125 = 12.7 inches wide and 9.25 inches tall. At 300 dots per inch that is 3,810 × 2,775 pixels.

Spine text. KDP prints text on the spine only past 79 pages; on a thinner book, leave the spine blank. Use the page count of your final interior PDF, blank pages included.

Upload it as one spread. KDP takes the paperback cover as a single PDF with the back, spine and front side by side. If you make coloring books, the AI coloring book generator makes the cover and interior as KDP-ready files.

The figures are from KDP’s cover and spine help page (topic G201953020), as of 2026-10-23, for Amazon.com (US), and the result is an estimate. KDP’s own cover calculator and templates are the source of truth: check your final size against them before you upload.

Keep going

Frequently asked

Still have a question? Write to us.

Width is the bleed, the trim width, the spine, the trim width and the bleed again; height is the trim height plus the bleed on the top and bottom. The calculator works it out for your trim size, page count and paper.

Extra artwork that runs past the trim line so no white edge shows after the book is cut. KDP asks for 0.125 inches on the top, bottom and outside edges of the cover.

The pixel size shown is the cover at 300 dots per inch, the usual print resolution. Build your file at that size or larger, scaled to match the dimensions.

Yes. The spine grows with the page count and the paper, so the full cover gets wider as the book gets thicker. The height does not change.

KDP takes the paperback cover as one PDF with the back, spine and front laid out as a single spread. Its cover templates show where each part goes.

No. It's a free estimator built on KDP's published figures. KDP's own cover calculator and templates are the source of truth for your final file.

Start with 50 free credits. No card needed.

Plan a book for free, write it with the free credits, and read every word before you pay for anything.